This is an original Bronton electric from 2021.
How could I tweak an accelerator or an on/off button without pedaling?
here are my findings:
crankset with torque sensor equipped with 16 magnets.
Five wires connector :
1 white (10v+)
2 black (Gnd)
3 blue (PAS sinus) 0v-4v
4 brown (PAS cosinus) 0v-4v
5 Gray (Torque) 2.5v-????? 0v
test 1: connecting (PAS sinus) via a led to (Gnd) it turns on and off at the frequency of pedal revolutions and that by turning forwards or backwards it is the same
test 2: exactly the same thing by connecting the led between (PAS cosinus) and (Gnd)
PAS sinus and PAS cosinus are ON in opposite mode.
test 3: connecting it between (torque) and (gnd) the LED remains aligth without turning the pedal but the more a load is applied to the pedal the more the LED becomes less and less bright until it goes out.
could anyone advise me?

How could I tweak an accelerator or an on/off button without pedaling?
here are my findings:
crankset with torque sensor equipped with 16 magnets.
Five wires connector :
1 white (10v+)
2 black (Gnd)
3 blue (PAS sinus) 0v-4v
4 brown (PAS cosinus) 0v-4v
5 Gray (Torque) 2.5v-????? 0v
test 1: connecting (PAS sinus) via a led to (Gnd) it turns on and off at the frequency of pedal revolutions and that by turning forwards or backwards it is the same
test 2: exactly the same thing by connecting the led between (PAS cosinus) and (Gnd)
PAS sinus and PAS cosinus are ON in opposite mode.
test 3: connecting it between (torque) and (gnd) the LED remains aligth without turning the pedal but the more a load is applied to the pedal the more the LED becomes less and less bright until it goes out.
could anyone advise me?
