jmwhite151
1 mW
I just finished installing the TDCM torque sensor in my Trek 4500. The instructions specify a certain orientation of the bottom bracket spindle with respect to the crank arm (see image). However, the square taper on my crank is oriented 45° differently than shown in the instructions (see other image). Is this a problem? Part of me thinks that it shouldn't make a difference. Another part of me thinks they wouldn't have specified it if it wasn't somewhat important.
If you have any experience/knowledge, please let me know. If I don't hear anything, I'll probably just go ahead and install my crank tomorrow or Monday and see what happens.
Thanks,
Jeff
If you have any experience/knowledge, please let me know. If I don't hear anything, I'll probably just go ahead and install my crank tomorrow or Monday and see what happens.
Thanks,
Jeff