Hello Ladies and Gents,
First time poster. I searched for an answer but couldn't find it. I hope you can help me brothers and sisters. I've had a Tongsheng motor with 650c display on my mountain bike for the past 6 months which is incredible. I crashed about a month ago and took out the display and replaced it and everything was working perfect. I only have display and throttle connections. Today, about 2 minutes after riding through a shallow stream, the motor shut off. I've ridden through this stream many times before without a problem. I turned it off and back on again and it worked for about 30 seconds twice. After that I get an error message on the display in the start up that says "error brakes" and won't go any further. There was some water splashed on the motor, but it was nowhere near submerged. I replaced the 1T2 connector with a new one, blew it off and placed it in the sun with no change. Any thoughts?
Thanks,
Shawn
First time poster. I searched for an answer but couldn't find it. I hope you can help me brothers and sisters. I've had a Tongsheng motor with 650c display on my mountain bike for the past 6 months which is incredible. I crashed about a month ago and took out the display and replaced it and everything was working perfect. I only have display and throttle connections. Today, about 2 minutes after riding through a shallow stream, the motor shut off. I've ridden through this stream many times before without a problem. I turned it off and back on again and it worked for about 30 seconds twice. After that I get an error message on the display in the start up that says "error brakes" and won't go any further. There was some water splashed on the motor, but it was nowhere near submerged. I replaced the 1T2 connector with a new one, blew it off and placed it in the sun with no change. Any thoughts?
Thanks,
Shawn
