Evelosimo
1 mW
This is my first installation of a TSDZ2 after having installed many Bafang middrives, so I am on a bit of a learning curve with this one.
I have been trying to install the open source software on my new 48V TSDZ2 and unfortunately after it was flashed with the new firmware, the 850C display is now dead and I am unable to turn the motor on. Thinking that maybe this was because I still needed to install the open source software, I went ahead and installed it using the proper cables purchased from Eco-Ebikes without any results which is also where I got all the software from. I have been pretty careful and everything seemed to load properly and all my drivers have been updated so I am a bit clueless as to where to go from here.
I have read somewhere on ES that this may be due to the fact that I have the new controller on my motor and it is not compatible with the OSS. I am not sure if there is any OSS available yet that would work with the new controller. Anyhow I am wondering if someone that has worked with these motors recently might know where I can find the original firmware to flash the display with, if at least I could just reinstall the original 850C display software, at least I can use the ebike, nevermind the OSS for now.
If anyone has any ideas, that would appreciated.
Thx
I have been trying to install the open source software on my new 48V TSDZ2 and unfortunately after it was flashed with the new firmware, the 850C display is now dead and I am unable to turn the motor on. Thinking that maybe this was because I still needed to install the open source software, I went ahead and installed it using the proper cables purchased from Eco-Ebikes without any results which is also where I got all the software from. I have been pretty careful and everything seemed to load properly and all my drivers have been updated so I am a bit clueless as to where to go from here.
I have read somewhere on ES that this may be due to the fact that I have the new controller on my motor and it is not compatible with the OSS. I am not sure if there is any OSS available yet that would work with the new controller. Anyhow I am wondering if someone that has worked with these motors recently might know where I can find the original firmware to flash the display with, if at least I could just reinstall the original 850C display software, at least I can use the ebike, nevermind the OSS for now.
If anyone has any ideas, that would appreciated.
Thx