Nucular electronics - complete kit for ev!

[PITMIX]

Hi, could someone tell me when the first deliveries of the 6F are expected?

 

[bigbore]

Hi, could someone tell me when the first deliveries of the 6F are expected?

Same for me! We're in the same boat!!!

 

[The Toecutter]

I am looking for a solution that will allow for me to run 3 motors at the same time. Is it possible to run 3 separate Nucular 6F, 12F, or X6F controllers in parallel off of the same throttle and/or torque sensor? My current temporary solution is to use 3 Phaserunners off of a CycleAnalyst v3, but each of those is only good for 96A phase current peak, and I want more power!

 

[PITMIX]

Yes, it's possible and it's written on page 1 of this discussion.

 

[The Toecutter]

I saw that, but it was written for the P24F. I'm tempted to order three of the 12F when available, the plan being to run 20S and 150A maximum phase current to two front hub motors plus running a middrive in the rear.

 

[PITMIX]

This applies to any model; what makes this possible is the Can bus.

 

[VasiliSk]

I saw that, but it was written for the P24F. I'm tempted to order three of the 12F when available, the plan being to run 20S and 150A maximum phase current to two front hub motors plus running a middrive in the rear.

new X6F should fit well for this task.

when the first deliveries of the 6F are expected?

actively preparing manufacturing, waiting for CN new year to end -_-. this year unless new apocalypse happens

 

[The Toecutter]

new X6F should fit well for this task.

actively preparing manufacturing, waiting for CN new year to end -_-. this year unless new apocalypse happens

I am certainly interested. X6F is a good match if I do 6kW peak per motor.

 

[VasiliSk]

Hello guys!
Looking for testers for Nucular Throttle!

After a long while we finally happy with result, ergonomic throttle that is not affected by handlebar shaking and does not cause muscle fatigue after a long ride. Left- and right-handed versions are available, with the thumb throttle acting as either a throttle or regen brake. Add note if you need custom wiring, by default it is made for display connector.

 

[DanGT86]

What is involved in being a tester? Do you need people to give you feedback on a set timeline?

 

[VasiliSk]

Yes i need feedback on how it feels, what is your ride style, is there any problems with it.
Also throttle is made with SLA atm, not injection molding