100volts+ wrote:
On another note, does anyone have a line on someone lacing MC rims to front MTB hubs?
Funny you should mention that. I would like to lace up a 19 x1.4 yamaha playbike rim to a 20mm axle with dual disc capability. It would match my rear tire. I hope I don't have to dish too much because I suck at lacing. However that is the point. I'm trying to learn.
I found that 1X such as on rear hub motors laced to rims is easy, but I flat suck at 3X. Of course I have never been instructed on this, and the time I tried it, I had no references. So for this reason, I wont mess with the front.
I'm still tempted to try a 3x it might end badly. I'll try to find a wheel smith ahead of my try in case of failure. Here are some good instructions I think.
[youtube]mOvD5UQo7r0[/youtube]