NeedForSpeed
1 W
- Joined
- Dec 31, 2017
- Messages
- 64
Hey all, I have incompatible connectors between my motor and controller and I'm trying to figure out what I should do.
Should I get adaptors (if they exist?), or should I replace one side with the same connectors? My father-in-law is an electrician so I'm guessing he could help me with this.
I have a Crystalyte t100 motor and Grinfineon C7240-GR controller.
Motor phase wires:
The motor has 3 x XT150 connectors
The controller has anderson powerpole connectors
Hall Sensor:
The motor has a all sensor plug: Mini XLR 5 pin
The controller has a JST-SM connector 5 pin
Controller: http://www.ebikes.ca/documents/Grinfineon_V2.1.pdf
Motor: http://www.evwarehouse.com.au/index.php/hub-motors/tc-100.html
Should I get adaptors (if they exist?), or should I replace one side with the same connectors? My father-in-law is an electrician so I'm guessing he could help me with this.
I have a Crystalyte t100 motor and Grinfineon C7240-GR controller.
Motor phase wires:
The motor has 3 x XT150 connectors
The controller has anderson powerpole connectors
Hall Sensor:
The motor has a all sensor plug: Mini XLR 5 pin
The controller has a JST-SM connector 5 pin
Controller: http://www.ebikes.ca/documents/Grinfineon_V2.1.pdf
Motor: http://www.evwarehouse.com.au/index.php/hub-motors/tc-100.html