Balance board and Lipo

[4wheels]

I am trying to connect my Balance board to the Battery, but its not working, it doesnt line up..

In the pictures you can see my Lipo plug, and the Balance board.

The prongs on the left side (of the battery) in the picture are in the way of the balance board prongs..
or the plastic on the board is in the way..

can I just cut part of the balance board plastic so that i can get the prongs?







also how low do you guys normally run your batteries?

 

[Nobuo]

first take measurements on the balance wires from the battery, is strange that those male and female connectors were not compatible. in that case you could just cut the two edges in the female connector in order to push further.

3.2V is a safe voltage for Lipo, lower is not safe.

 

[4wheels]

The edge on the battery do not get in my way..

what gets in the way is the plastic clip on the board its self. Can i just this clip off on the board?

The board says xh, and my battery is xh, yet its not compatible..

 

[4wheels]

Also i am able to fit the 2 plugs together if i have them the wrong way.. just the right way they wont fit...

 

[drew12345]

Not sure if I understand correctly but remember I had similar situation from the balance board plug to charger. I had to shave down the two clips for the end that went to charger so I could flip around the plug. This was on an icharger. Just made sure the negative wire on clip goes to negative side on charger. Not sure if same situation.

 

[4wheels]

Thats what i ended up doing, i just made it fit more or less.. Battery hasnt exploded yet..

I figured aslong as + goes to + and - goes to - that i should be fine.

and yeah im using an Icharger aswell.


Thanks for the help!

 

[dnmun]

your pictures are spam. is that the entire reason for this post, just to post spam?

 

[4wheels]

How are the pictures of me showing my connecters, and attempting to help explain my issue spam?
Please elaborate, as i certainly was not trying to spam here..

Thanks!