NeilP
1 GW
from one page back...so you may get 6 or 7mA at 96 volts . So you are going to need a DC-DC convertor.teklektik said:Exactly. Pretty painless. You are good to run a hall throttle up to 100v, but you're a bit over the line....NeilP said:How would I do that? Can I just connect the 5 volt from the controller direct to the throttle input then? and output the hall throttle output direct to the CA.teklektik said:... but at 134v you only have 2ma total (5v and 10v) current available - not even enough to run a hall throttle... (typically 5ma) so you will need to steal some 5v from the controller just to run your throttle (unless you have a Magura which only needs 1ma).
If I have understood teklektik correctly then anything much over 50 volts and you really need an external supply the built in one is not up to it for anything above the low voltage setups.
See the circuit teklektik posted on the last page. or search the meanwell site for suitable supply..or go the mini pc/notepad PSU route. it seems the only option till there is a hardware upgrade to the power supply side of the CA