DKD battery indicator

[tedo]

This DKD always shows full. Should the battery indicator have come down yet? I set it to 96v, but also did the "manual calibrate" at 96v. See pic. Actual is still shows 104.9, but my battery capacity on fardriver shows only 77%.

 

[tedo]

I have read about this somewhere and can not find it. I have a QS hub and my fardriver insist that my Max RPM is 3000. When I change the "pro mode" settings to 1670 it mathematically lowers to the equivalent of 55% of 3000 on the "simple mode" page. If I change the simple mode back to 100% it gives me 3000 on the pro page. It does this with the 800 line amps and 1800 phase amps also. See pics it will make more sense. Should I just leave it alone like it is in the pics?

 

[E-HP]

So looks like 10 bars. Assuming you set “it”means the nominal voltage of the battery, then I think thats 26s. if it’s a lithium pack, then full charge is 109.2v. So 104.9/109.2 = 0.961 or still 96% charged. Might not have reached the voltage to go down a bar.
Not sure what’s going on with the controller and the 77%.

 

[tedo]

Oh ok. That makes sense. Not sure which indication to believe. Looks like 77% is the outlier

 

[tedo]

So looks like 10 bars. Assuming you set “it”means the nominal voltage of the battery, then I think thats 26s. if it’s a lithium pack, then full charge is 109.2v. So 104.9/109.2 = 0.961 or still 96% charged. Might not have reached the voltage to go down a bar.
Not sure what’s going on with the controller and the 77%.

The battery bar finally dropped 1 line at 73% and is still there at 66%. LOL. I think it is just not accurate. OneLin connection.

 

[E-HP]

Maybe they sent you the 84V or 72V version of the display by mistake.

 

[tedo]

Maybe they sent you the 84V or 72V version of the display by mistake.

It showed 96 when tlI went to set the volts. I did figure out setting the bit rate to "6" made the amps bar work. Although I think the bar caps at 110 so not that useful.