JB_EB said:So just to confirm, this board takes care of:
- Charging and equalising of the individual cells in the pack.
- And provides a Low Voltage Cutoff signal that can be connected to the e-brake switch on the controller to prevent over discharge?
In addition, all that is needed is a power supply that is a few volts greater than 3.65v x (Number of cells in series) and with sufficient Current to charge the pack in your required time, plus some high-current connectors. Is that correct?
JohnB
Correct. The connector to the charger needs two high current contacts, and two low current contacts (or an integrated switch on the BMS side).