gocartpleasegokart
1 µW
- Joined
- Mar 18, 2019
- Messages
- 2
Hello everyone,
I am working on a go kart project that has been on hold because we cannot get the motor to run
The motor is an 1800W BLDC: MY 1020
While the controller included a wiring diagram, I am still unable to successfully run the motor.
I have connected the three phase wires for the motor (green, yellow, blue) and the hall sensor plug block of five wires from the speed controller to the motor. This system seems to have a harness that leads to a set of other wires which is why I have attached a second picture below.
The wiring diagram says the orange and red wire is the ignition switch, and so I tried connecting them together and plugging in the battery but still nothing happens
Please help me out
EDIT:
Included the link to the pictures below:
Thanks!
I am working on a go kart project that has been on hold because we cannot get the motor to run
The motor is an 1800W BLDC: MY 1020
While the controller included a wiring diagram, I am still unable to successfully run the motor.
I have connected the three phase wires for the motor (green, yellow, blue) and the hall sensor plug block of five wires from the speed controller to the motor. This system seems to have a harness that leads to a set of other wires which is why I have attached a second picture below.
The wiring diagram says the orange and red wire is the ignition switch, and so I tried connecting them together and plugging in the battery but still nothing happens
Please help me out
EDIT:
Included the link to the pictures below:
Thanks!