Hooking up Halls with USB

Should be fine, the only issue would be if the insulation melted at low temps, as it runs into the hub.
 
Ok cool, ill use it. I dont plan on running the wire to the inside of the hub. So hopefully i will be ok.

Ill try to post a pic later. Dont have the cable with me. No discernable markings on the wire itself.

...any idea what wire i can use to extend my balance wires.. anyone have a good source. Looking to parallel them up for charging.
 
Slightly related: HE Cabling: Micro B USB Connectors

It seems to me that I ran Ethernet wires through the axle to eliminate the USB covering because I pulled 12-AWG stranded wire though for the Phase, and it was a bit tight. That's explained here: RUST: DIY Hub Motor Repair & Restoration

Been running the USB cable on the HE for all of my 2WD miles without failure. 8)
~KF
 
Back
Top