So I own a Benifore C26 and I'm at wits end. I had my wires frey and snap at the connector on the controller side. My motor is a 750 w and that is perfectly fine. So here's the issue the connector is not the standard julet z910 9pin. This connector is a linkwe 910c 9 pin connector. Before anyone says it will fit with the standard julet 9 pin waterproof connector it does not fit as the 3 phase pins are slightly larger. In the process of the wires freying and snapping it fried the controller. I've already contacted benifore and they are unable to make me a replacement. So if anyone has a suggestion for a controller and display combo that uses that type connector or any leed on an extension that goes from the standard julet 9 pin waterproof connector to the linkwe 910c connector. I'm loosing my mind can anyone help. I've attached pictures of the original controller label and an image of the linkwe connector.
-
Hello ES! We could use some help to get us past the finish line on building the new knowledgebase for the forum.
Can you donate? Please see our fundraising page. Thank you!
Looking for controller options
- Thread starter nashty420
- Start date
Can you provide a pic of the controller with all of the connectors and connectors visible like in the link below? You will need to replace the display as well, if you intend to replace the controller. Personally, I’d swap out the motor connector with the standard julet while you’re at it. Also, provide a list of the functions and peripherals the bike currently has (e.g. throttle, PAS, etc.)
Troubleshooting - How to Receive Assistance (work in progress)
Purpose: This thread includes some tips on what types of information to provide in order to receive prompt advice, and the level of detail ideally available to diagnose the issue. Ebike troubleshooting requires information that in most cases, only the requestor can provide or has access to. The...
endless-sphere.com
Similar threads
- Question
