Hi all. My project is still not running right. Apparently the wiring diagram I got had the throttle and PAS wires mismarked, and I had the PAS connected to the throttle. (explains the choppy application of power). Anyway, I went to add a throttle and found the error. I now have throttle, but no PAS.
It's a 250w geared rear hub motor, 36V battery, KT 36v dual mode controller, and LED880 control panel. Brake sensors, throttle, walk assist, and led's all work. I have 5v at the PAS wiring, and I have 3 different, all tested good, PAS sensors. None work with this controller, or the controller PAS circuit does not work.
ANy thoughts on next steps? I'm quite happy that I was able to add a throttle due to the upgraded controller, but I would love to see the PAS work, too.
Thanks for any help.
It's a 250w geared rear hub motor, 36V battery, KT 36v dual mode controller, and LED880 control panel. Brake sensors, throttle, walk assist, and led's all work. I have 5v at the PAS wiring, and I have 3 different, all tested good, PAS sensors. None work with this controller, or the controller PAS circuit does not work.
ANy thoughts on next steps? I'm quite happy that I was able to add a throttle due to the upgraded controller, but I would love to see the PAS work, too.
Thanks for any help.