Hi All
I am troubleshooting my GMAC10 Regen Motor with Phaserunner and CA3.
The Problem/s
A) no power transfer to hub. So...tried to connect to Phaserunner suite (V1.4).
Initially got the Fault messages:
Warnings [1] Hall Sensor
Warnings [6] Hall
B) Later tried using Phaserunner Suite...got the message "Controller is not connected". This means I can't set parameters etc.
The Question/s
A) How can I fix the "Controller is not connected" issue?
B) Where is the support page for the Phaserunner Suite? ie how can I learn what the Warning and Faults messages are so I can correct these?
Thanks in advance
I am troubleshooting my GMAC10 Regen Motor with Phaserunner and CA3.
The Problem/s
A) no power transfer to hub. So...tried to connect to Phaserunner suite (V1.4).
Initially got the Fault messages:
Warnings [1] Hall Sensor
Warnings [6] Hall
B) Later tried using Phaserunner Suite...got the message "Controller is not connected". This means I can't set parameters etc.
The Question/s
A) How can I fix the "Controller is not connected" issue?
B) Where is the support page for the Phaserunner Suite? ie how can I learn what the Warning and Faults messages are so I can correct these?
Thanks in advance