TSDZ2B display problem with OSF

[RocknRoller]

Hello,
I got a new TSDZ2 and now installed OSF v20.1C.2. I had already successfully done this on another bike a year ago. The only two differences from the first bike are a different display (now VLCD6 instead of VLCD5) and a smaller battery. I changed this information in the input mask. Now, after flashing, no speed is displayed, and only one bar shows a full battery! What did I do wrong?

 

[RocknRoller]

I probably have a crazy problem that no one else has had before....?

 

[Matze_Senpaii]

i would think that one of these happened;

-something went wrong with firmware: try installing osf again
-your display connection is bad: see if all plugs are good and replug all cables again

 

[Matze_Senpaii]

also i see on your picture your battery capacity is only 180wh. is that right?

 

[docw009]

No speed? OSF firmware prefers a different magnet spacing to speed the sensor. Mine didn't work either with OSF, but it did when I went back to OEM firmware. I went back to OSF and fiddled around with the sensor til it worked. I recall that if it were too close, I would get double and triple hits,

Battery? The numbers flashed onto the display during powerup for VLDC5 include a percent reading and voltage. Like 10.0 is 100%, followed by a numeric voltage. You might look to see if that works. The battery usage is also calculated off the default number (180WH in your case). It's not really important to me.

 

[RocknRoller]

thank you all for your answers !

also i see on your picture your battery capacity is only 180wh. is that right?

yes thats right !

display-connection: the display (VLCD6) worked normal before OSF was installed. Did not disconnect it
speed-sensor: tried a second one, also in different locations.....no changes...
battery: tried a bigger one.....also only one bar in the display
OSF: tried several installations...

Unfortunately, I can't think of anything else now

 

[mbrusa]

Probably option_byte is corrupt.
Try flashing option_byte.hex with ST Visual Progammer.
I recommend using the latest version of OSF.