Hello,
I have a mountainbike with a astroflight 3215 connected to the rear wheel with a 2 stage reduction. On the intermediate shaft I have a freewheel, the ratio from the motor to this shaft is 4:1.
motor controller is a vesc 6.4
Battery is 12s.
motor kv is 169
Phase current set to 60 A
throttle controls duty cycle
The motor wizard did a good job and the combination works great, except for one big problem.
Problem:
When I reapply throttle after coasting (wheel spinning at 10 - 30 kph. motor stopped, freewheel working.), it happens that the motor starts making a squeezing sound and doesn't move anymore.
I think the controller looses sync
seems only to happen at certain throttle position while reapplying it. low throttle or full throttle seems to work ok. Half throttle seems to give the problem.
squeezing sound continues until I disconnect the battery
What I think happens:
The motor spins up
when the motor speed matches the wheel speed, the freewheel engages abruptly and causes a big torque ripple.
controller looses sync
Is this a known issue?
Can I tweak some parameters to solve this problem?
thank you!
Roel
I have a mountainbike with a astroflight 3215 connected to the rear wheel with a 2 stage reduction. On the intermediate shaft I have a freewheel, the ratio from the motor to this shaft is 4:1.
motor controller is a vesc 6.4
Battery is 12s.
motor kv is 169
Phase current set to 60 A
throttle controls duty cycle
The motor wizard did a good job and the combination works great, except for one big problem.
Problem:
When I reapply throttle after coasting (wheel spinning at 10 - 30 kph. motor stopped, freewheel working.), it happens that the motor starts making a squeezing sound and doesn't move anymore.
I think the controller looses sync
seems only to happen at certain throttle position while reapplying it. low throttle or full throttle seems to work ok. Half throttle seems to give the problem.
squeezing sound continues until I disconnect the battery
What I think happens:
The motor spins up
when the motor speed matches the wheel speed, the freewheel engages abruptly and causes a big torque ripple.
controller looses sync
Is this a known issue?
Can I tweak some parameters to solve this problem?
thank you!
Roel