vesc problem high offset on current sensor 3,

[kam]

I have a vesc controller type FLIPSKY 4-13S Lipo ESC Speed Control Mini FSESC6.7 70A, I tried it on a bafang motor and everything seemed fine.
I put it back on the Bosch which is the bike I'm trying to modify and now I'm hearing the detection failed. reason: high offset on current sensor 3, check for hardware failure.' I've checked the voltage, wires and firmware and checked the MOSFETs, but they seem fine. I tried it on another engine but it didn't work. In the end I ordered another one and I'm waiting for it to arrive, does anyone know what other tests I can do to find out the problem
thanks

 

[qwerkus]

I have a vesc controller type FLIPSKY 4-13S Lipo ESC Speed Control Mini FSESC6.7 70A, I tried it on a bafang motor and everything seemed fine.
I put it back on the Bosch which is the bike I'm trying to modify and now I'm hearing the detection failed. reason: high offset on current sensor 3, check for hardware failure.' I've checked the voltage, wires and firmware and checked the MOSFETs, but they seem fine. I tried it on another engine but it didn't work. In the end I ordered another one and I'm waiting for it to arrive, does anyone know what other tests I can do to find out the problem
thanks

Most likely a hw defect on your controller board. I had the same on a spintend; usually crappy sensors. Try with a different motor, if you can, to confirm. If the same error persists (most likely) you can start the tedious complaining process with flipsky...

 

[kam]

yes I already tried with another engine but it does the same and st32 reaches 59° without motor but it connects via USB and also sends data see temperature
thanks

 

[Viktorrr]

Please tell me. I'm currently dealing with a similar problem. Do you have a second-generation Bosch engine? If so, how did you position the Hall sensors?