Hi all
My project (electric go kart) is almost finished but I've hit a problem that I can't seem to figure out. Any ideas would be greatly appreciated.
My controller doesn't respond to the throttle application. The only way to get it to spin the motor is through connecting the "self-learning" wires together. Upon connecting them it acts strangely and I don't know what to make of it. The motor will run at a medium speed in one direction. If I give the throttle a twist, it will then stop and then run in the opposite direction. It will continue to run until I twist the throttle, whereupon it will stop and reverse again. If I hold the throttle, it stops and then spins in the opposite direction twice as fast until I let it go. And then it the same story again...
Any one had the same issue?
Controller - Sunwin SH60U45GV18T-WZ2
Motor - Heinemann PMS120-WB294
My project (electric go kart) is almost finished but I've hit a problem that I can't seem to figure out. Any ideas would be greatly appreciated.
My controller doesn't respond to the throttle application. The only way to get it to spin the motor is through connecting the "self-learning" wires together. Upon connecting them it acts strangely and I don't know what to make of it. The motor will run at a medium speed in one direction. If I give the throttle a twist, it will then stop and then run in the opposite direction. It will continue to run until I twist the throttle, whereupon it will stop and reverse again. If I hold the throttle, it stops and then spins in the opposite direction twice as fast until I let it go. And then it the same story again...
Any one had the same issue?
Controller - Sunwin SH60U45GV18T-WZ2
Motor - Heinemann PMS120-WB294