mcninch318
🧲 New user
Hello all!
Trying to build a Wolf King/Teewing Scooter. Was wondering if anyone has ever used wolf king controllers without the logic board the scooter comes with. Seems fairly straight forward as long as I figure out wires for display/throttle/ brakes etc.
So far I have the display getting power, shows code 10 but the rear motor is unplugged. Hoping that will fix it!
Throttle is wired and receiving 5V and signal wire (yellow/white) is reading good.
Unable to get the front motor to spin so far. When I meter the hall wires and spin the wheel the voltage fluctuates, at is should, I believe.
Any help with this would be greatly appreciated!!
Trying to build a Wolf King/Teewing Scooter. Was wondering if anyone has ever used wolf king controllers without the logic board the scooter comes with. Seems fairly straight forward as long as I figure out wires for display/throttle/ brakes etc.
So far I have the display getting power, shows code 10 but the rear motor is unplugged. Hoping that will fix it!
Throttle is wired and receiving 5V and signal wire (yellow/white) is reading good.
Unable to get the front motor to spin so far. When I meter the hall wires and spin the wheel the voltage fluctuates, at is should, I believe.
Any help with this would be greatly appreciated!!
