Hi all, I'm completely new to this so please bear with me.
If I were to get some laminations cut for me by a 'laser' guy I know would any burrs produced be a problem? If I was to remove these burrs with, say, a file would the bare metal then need to be coated with an insulating varnish or something?
Best Regards
Rob
If I were to get some laminations cut for me by a 'laser' guy I know would any burrs produced be a problem? If I was to remove these burrs with, say, a file would the bare metal then need to be coated with an insulating varnish or something?
Best Regards
Rob