Hi Bill,
Thanks for your reply.
I did have the poll button pressed (it turned blue). The read button turns blue only until you select something else, so I think it just reads once. Neither selected does not do anything. Do you remember if it is normal for the 1 or 2 in the motor discovery box to instantly switch back to 0 when write is pressed?
I did not realize that the status button was not suppose to be red. I thought it was telling me it was connected. Opps. I held my cursor over it and it reports 'bit 5 Motor Halls sensors fault 15 LED flashes'. Try a quick end run and go to sensorless mode. This clears the status light but when I go to Basic Motor (sensorless) and put 1 in motor discover mode, I get 'bit 7 POST static gating test (3 LED flashes). The one does not instantly disappear from the motor discover mode box but there is no autotune results.
I guess I will try the method outlined in the BAC controller manual ver 1 to manually check halls.
Thanks for your reply.
I did have the poll button pressed (it turned blue). The read button turns blue only until you select something else, so I think it just reads once. Neither selected does not do anything. Do you remember if it is normal for the 1 or 2 in the motor discovery box to instantly switch back to 0 when write is pressed?
I did not realize that the status button was not suppose to be red. I thought it was telling me it was connected. Opps. I held my cursor over it and it reports 'bit 5 Motor Halls sensors fault 15 LED flashes'. Try a quick end run and go to sensorless mode. This clears the status light but when I go to Basic Motor (sensorless) and put 1 in motor discover mode, I get 'bit 7 POST static gating test (3 LED flashes). The one does not instantly disappear from the motor discover mode box but there is no autotune results.
I guess I will try the method outlined in the BAC controller manual ver 1 to manually check halls.