Axiom: a 100kW+ motor controller

[9277]

Excuse me, is the program used in the FPGA component in this circuit configured by downloading the relevant firmware directly? Or do you need to use special hardware to connect to the computer and configure it separately and then weld it on the pcb?

 

[9277]

Hello, I am an engineer engaged in the design and development of permanent magnet synchronous motor body and motor control. I think the design and performance of this motor controller product is very good. The question I want to ask is above.

 

[HighHopes]

FPGA comes pre-programmed, so there's nothing for you to do there.

 

[Aquinax]

Hi everyone, great project! I was just dreaming only about it. Because everything that's whole on sale is kind of childish, what is 72, 96 volts? It's a lot for bicycles, but it's not enough for motorcycles. As for me.
So how do I get this to test and I can see staying with it?
I prefer to start with a 40-45s battery or will it still work with my existing 20s battery?
When do you expect to distribute the product for commercial purposes if I can't get into the testing community?