Bafang GO+ parameters change

[DPC18RI]

Update: All solved now. After buying new canable, this time V1.0 with STM32F072CBT6 with Candlelight firmware on it. Autodetect in windows can still hit or miss. It has WCID USB descriptors and some of my computers (2 from 5) can detect it and windows installs automatically the driver for usb port. The other 3 would not. I installed manually the driver.

@stancecoke, on the board is a tx and rx led but they do nothing in my case although the device works. Just the red 3.3V led is lit.

 

[stancecoke]

Autodetect in windows can still hit or miss.

Hm, I tried it on a third computer, it worked automatically also.

 

[DPC18RI]

Yep i have exact the same value's as you show in the picture for "Hardware ID's". But if i click above it on "treiber" next to "details" then on mine it says / comes down to "no driver is installed". So i had to install one myself on the laptop where i use the device on.
Even if the hardware is exactly the same, the software can still differ, older or newer depending on where you buy them from i guess.
On your device do the RX and TX light up during use? On mine they do not light up during use although the device works fine now.

 

[stancecoke]

On your device do the RX and TX light up during use?

No, but UART Rx and Tx are not used normally. The pins are available on the header, but mainly for a firmware update via UART with the native STM bootloader, I think.
The BOOT0 pin and the SWD interface are available also.