Hey guys,
Thank you for your replies! So last night I fully charged it, not getting hot at all.. Before with old bms, the steel battery would warm up quit a lot..
Also the voltage today is the same like last night, exactly the same when I checked, 66.9volt.
Today I connected all lights, see picture, that is A Lot of light haha. With all the lights on, it dropped only till 66.8v, that is nothing! And returned afterwards to 66.9v again fast.
Today the new BMS came in, the 150A bluetooth I showed you. This Bms is for my most important, very expensive Panasonic 60v46Ah Powerpack.
I have a very good relationship with scooter fabric, especially because I bought 2, and many spare parts. They would not lie to me about the battery pack.. Selling me crap for very expensive. Itvs a widely trusted scooter fabric, I consider them as my friends.
So the new bms for the new pack.. This one has some wires already, but looks also different again.
-Firstly I have 2 controllers and need wires for 2 controllers. And ik only see 1xB-. Kan I just solder an extra wire next to it on silver colored part?
-I use 2 x 5A charger at the same time, that is stock, connector ports made in the scooter. Can I solder another wire next to rhe C- for the second charger?
-1 of those 2 white connectors op the bms board, the big ehite connector, seems.. The.. Same.. Size.. As.. Old.. White connector...
Just push it in? Haha I do not think possible, but you never know...
-that thin red and black wire, where are those for?