Cycle Analyst V3 preview and first beta release

AW, that is something I've occasionally thought about solving as well. Also because it's just nice to ride without a screen in the face sometimes.

If I find the time, I might design a 3D printed flip down cover. Printed in black, it should block 90%+ of the light. That would be the easiest way IMO.

Cheers
 
Hmf. I never even thought of printing a cover***.... :oops: I would rather do that than modify the electronics. If you ever make a design, lemme know and I'll try printing it out.

If it's made as a cover kinda like a phone case where it has sides to go down over the CA's sides, it'll block light pretty completely, if the hinge itself is below the rounded edge of the forward CA side.

If someone needs to use it on a system that uses presets changed by the front panel buttons, then if it's made thin enough around the button area with thicker bumps where the buttons are it shouldn't need any holes, if it's printed with soft enough TPU. I have a roll in black shore95A and another in gray (95A), which are hard but flexible enough for this if printed thinly. 1742597066028.png

If I ever run into the time to design one, i'll post it up here. (but don't hold your breath :lol: )


***which is pretty wierd since I once wanted to print a new back cover that would have connectors "molded" into it similar to the ebikesolutions cover; that was long ago before I actually had a printer.
 
Last edited:
Back
Top