DesignerDan
100 mW
- Joined
- Sep 8, 2011
- Messages
- 42
>Got hubzilla
>bolt it to frame
>solder wires to infineon controller
>yellow to yellow, green to green, blue to blue
>Test it out
>11 amp no load current
>motor making funny noises
>Check to see if anything is rubbing against motor
>motor and wheel spin freely
>double check wiring
>triple check wiring
>check the entire length of wire for shorts until the part where it enters the motor
>confused
>keep trying it anyway
>controller burns up
>me = sad
Okay it seem like it has to be the halls right? I checked the wiring and connections so many times and all of that is good. I can't think of anything else it could be except the hall sensors. I'm a little pissed of because generally when you spend 600 dollars on a motor you expect it to have working halls. I'm also a little ticked off about my controller. But I guess that was my fault for continuing to try it even though obviously something was wrong. GRR. Any advice?
>bolt it to frame
>solder wires to infineon controller
>yellow to yellow, green to green, blue to blue
>Test it out
>11 amp no load current
>motor making funny noises
>Check to see if anything is rubbing against motor
>motor and wheel spin freely
>double check wiring
>triple check wiring
>check the entire length of wire for shorts until the part where it enters the motor
>confused
>keep trying it anyway
>controller burns up
>me = sad
Okay it seem like it has to be the halls right? I checked the wiring and connections so many times and all of that is good. I can't think of anything else it could be except the hall sensors. I'm a little pissed of because generally when you spend 600 dollars on a motor you expect it to have working halls. I'm also a little ticked off about my controller. But I guess that was my fault for continuing to try it even though obviously something was wrong. GRR. Any advice?