Cyclomania
10 kW
So, I have an existing PAS-sensor on one of my bikes. I don't want to change the whole PAS-sensor. But instead have an extension cable so I can change between controllers.
Now, I am going to change controller in a little while so I need to create an extension cable from my Julet connection going from the PAS sensor on the bike to my new controller.
The new controller has a CSC pas connection. Therefore I need an extension cable between the controller connection and the Julet connection from the PAS-sensor. Julet on the PAS-end and CSC in the other end.
Since I haven't found a good cable for this purpose on ALI or Ebay my plan is to cut off a bit of cable with connection, from one of my other PAS-sensors that I bought, compatible with CSC, and solder it onto another cable I have which is compatible with Julet in one side. See pictures.
Now, as you can see from the picture, the cables that are going out of the Julet on the no-connection-side does have different colors from the connector that I am going to try to cut of and solder on there. Red, white and black from the Julet cable. And Blue, yellow and red in the CSC-connector.
Therefore, I am not sure which color should be soldered on and put where, to get them in the right order. Could anyone come up with an idea for how to figure this out?
Thanks
Now, I am going to change controller in a little while so I need to create an extension cable from my Julet connection going from the PAS sensor on the bike to my new controller.
The new controller has a CSC pas connection. Therefore I need an extension cable between the controller connection and the Julet connection from the PAS-sensor. Julet on the PAS-end and CSC in the other end.
Since I haven't found a good cable for this purpose on ALI or Ebay my plan is to cut off a bit of cable with connection, from one of my other PAS-sensors that I bought, compatible with CSC, and solder it onto another cable I have which is compatible with Julet in one side. See pictures.
Now, as you can see from the picture, the cables that are going out of the Julet on the no-connection-side does have different colors from the connector that I am going to try to cut of and solder on there. Red, white and black from the Julet cable. And Blue, yellow and red in the CSC-connector.
Therefore, I am not sure which color should be soldered on and put where, to get them in the right order. Could anyone come up with an idea for how to figure this out?
Thanks