Hey guys,
Just pulled out the old build.
Crystalyte controller with a geared BMC.
Could use some collective brainpower with this one
Soooo...
The motor has some resistance to being spun backward when speed control is on, won't start up until I give it a manual whirl, then won't stop spinning until speed control is cut.
Also, cycleanalyst says it's eating AH even when hub is disconnected and speed at 0.
Alsoso, getting big jumps in the power feed from the controller to the hub. With speed up, I get no output, then suddenly full.
Any ideas?
Just pulled out the old build.
Crystalyte controller with a geared BMC.
Could use some collective brainpower with this one
Soooo...
The motor has some resistance to being spun backward when speed control is on, won't start up until I give it a manual whirl, then won't stop spinning until speed control is cut.
Also, cycleanalyst says it's eating AH even when hub is disconnected and speed at 0.
Alsoso, getting big jumps in the power feed from the controller to the hub. With speed up, I get no output, then suddenly full.
Any ideas?