Hey guys, my Adaptto Max-E is doing crazy since some days.. Maybe you can help me with this problem:
Before it was doing crazy, it worked just fine and I was able to ride about 9-10 kilometers, but after connecting the cables of my Tektro Dorado Brakes from Vector, it was like going absolutly crazy.. I have already checked together with my uncle, who is an electric-engineer, if I have connected some cables wrong, but he says that I did everything right.
So some little explaination: Everything worked fine for 9 kilometers.. Then I had less battery left, why I decided to install regen braking to save some energy (because my Eaton charger didn´t get delivered yet because german post didn´t do their homework). So then I installed the cables. After doing that I recognized, that I was only able to push the throttle, when pressing the brake button at the same time.. I hadn´t had my soldering iron with me and have been already on the half of the way, why I didn´t installed it back. So after riding to local bicycle store and installing my chain I rode back and let off from throttle and brake button at the same time, which caused a like ermergency braking. After this everything didn´t work anymore. I cut the cables from the throttle away, hoping that the throttle will work again, but nothing. I had to push my bike the last 500 meters back home, while my rear wheel was like already blocked a bit by the magnets. (To explain this blocking thing: It feld like every single magnet of the motor did not want to move. Like "going over this magnet" was hard, but then it was easy to push the bike untill the next magnet came).
My Vector half twist throttle gets recognized by the controller when doing calibration. But when I am out of the menu, means the normal display when riding, it is not working anymore. Just like it would not exist. Sometimes, and this "sometimes" is really annoying, it shows "protective" where it normally says "Eco, normal, boost", when twisting the throttle 50%. Also when I try to autodetect, sometimes the throttle works, sometimes not.
If the throttle finally works, after resetting of the controller via <Setup>, etc. it says "Halls error 2", sometimes instead of "Halls error 2" it says "Halls error 1"... :|
Another problem: Yesterday, after 5-6 hours of trying to fix this problem, the throttle finally got recognized, but not in this way that the wheel starts to spin, but that the wheel gets blocked just like giving extra energy into the motor so that the wheel can´t spin..
:? :|
I would really appreciate your help...
PS: When trying to charge the battery via 30A coil and laboratory charger with 20 volts, 30 amps, the motor sometimes starts to spin, while the charger goes really hard with the Ampere (up to 20 Amps), the volts still stay at 0-2 volts. Also I want to mention, that I have already switched the 6 hall sensors from the motor, but it still says "Halls error 2" and "..1". Also: I have already reseted my controller more then 2 times via <Setup> etc..
-Elias
