Powahwheels
1 µW
- Joined
- Nov 6, 2022
- Messages
- 1
Hi,
I am fairly new to the world of brushless motor controllers. I recently purchased a 1000w brushless motor controller from Amazon. I wired it up with a sensored motor and it seemed to work just fine. When I tried to use it with a sensorless motor, the controller generally works at very low throttle inputs but shuts off randomly. Sometimes it will shutoff after a few seconds at 1/4 throttle and sometimes it will let me go 10+ seconds on full throttle. The only way to get the controller back is to cycle the power switch line.
I put the controller in the low gear mode and it seemed to help but the issues still remain.
I am using a Ryobi 40V battery as the power source but I don't think it's a battery issue since I can run a sensored verison of the motor with no shutoffs. And, the battery should give me an overcurrent notification on the fuel gauge if it is tripping that. Any ideas?
Link; https://www.amazon.com/dp/B07JJX5PNW?psc=1&ref=ppx_yo2ov_dt_b_product_details
I am fairly new to the world of brushless motor controllers. I recently purchased a 1000w brushless motor controller from Amazon. I wired it up with a sensored motor and it seemed to work just fine. When I tried to use it with a sensorless motor, the controller generally works at very low throttle inputs but shuts off randomly. Sometimes it will shutoff after a few seconds at 1/4 throttle and sometimes it will let me go 10+ seconds on full throttle. The only way to get the controller back is to cycle the power switch line.
I put the controller in the low gear mode and it seemed to help but the issues still remain.
I am using a Ryobi 40V battery as the power source but I don't think it's a battery issue since I can run a sensored verison of the motor with no shutoffs. And, the battery should give me an overcurrent notification on the fuel gauge if it is tripping that. Any ideas?
Link; https://www.amazon.com/dp/B07JJX5PNW?psc=1&ref=ppx_yo2ov_dt_b_product_details