tomtom123
100 W
Lulehenke said:My project, Giant Warp
* New build frame
* Mac motor kit
* 72V battery
* Cycle analyst
How did you make the triangle Frame
Lulehenke said:My project, Giant Warp
* New build frame
* Mac motor kit
* 72V battery
* Cycle analyst
veloman said:shenzhen_ex said:This thing just looks badass. Nice work.
Ch00paKabrA said:here is my second build. I didn't take a picture before so here is one from the website:
Before:
![]()
After:
![]()
I was going for a stealthy look so hopefully you won't see too much of a difference.![]()
tomtom123 said:Ch00paKabrA said:here is my second build. I didn't take a picture before so here is one from the website:
Before:
![]()
After:
![]()
I was going for a stealthy look so hopefully you won't see too much of a difference.![]()
What motor and battery u running? Where your controller BTW? In the bag? Looks very stealthy
Ch00paKabrA said:tomtom123 said:Ch00paKabrA said:here is my second build. I didn't take a picture before so here is one from the website:
Before:
![]()
After:
![]()
I was going for a stealthy look so hopefully you won't see too much of a difference.![]()
What motor and battery u running? Where your controller BTW? In the bag? Looks very stealthy
The motor is an MW Motors 36v 250w minihub. It is made by Bafang for them so it does not say "8fun". If you look carefully at the chainring/crank setup, you can just see the controller peeking out. Since this bike has a bottom pull front deraileur, I used the screw for the guide plate to hold the bottom of the controller and 2 zip ties to hold the front.
I use Bosch Fatpack clones. I disect them and put 2 36v 3ah in parallel in the under seat bag.
Hope that answers your questions, if not feel free to PM me.
what bike rack is that? it looks sturdy as hellev tocak said: