I have a little 6 FET controller (25A) and am looking to tidy up the wiring because with the current multitude of plugs and leads it resembles a big bowl of spaghetti. :-(
So I'm going to take it out of its current housing and install it into an aluminium diecast box with 3 sockets mounted onto the sides of the box:
- a DB25 socket which handles all the signal/control wiring, so thats under control.
- a socket (and matching plug) for the battery wires.
- a socket (with matching plug) for the 3 phase wire for the motor.
Any recommendations for the socket and plug combos?
So I'm going to take it out of its current housing and install it into an aluminium diecast box with 3 sockets mounted onto the sides of the box:
- a DB25 socket which handles all the signal/control wiring, so thats under control.
- a socket (and matching plug) for the battery wires.
- a socket (with matching plug) for the 3 phase wire for the motor.
Any recommendations for the socket and plug combos?