nioko
100 W
Hello Everyone
I have successfully replaced the bearings in my BionX 250HT motor two weeks ago. After this I've done about 200km on it without any issues, it was running perfectly smooth, so I don't think that it is related.
Anyway, yesterday - I'm not 100% sure, but I think while braking (recup). The thing suddenly started to stutter. When I pedaled again, it stuttered even more. The support by the motor went on and off. I have switched to PAS level 1 which was a lot smoother, but I guess it is due to less power involved.
The speedo showed incorrect values, and when I set PAS to 0, the speedo showed 0kph.
So my assumption is at least one of the hall sensors died, but I wonder what you guys think?
Does anyone know what kind of hall sensors I need to buy? I'd like to order them ASAP, before I have the time to disassemble the motor again.
Cheers from Switzerland
Nico
I have successfully replaced the bearings in my BionX 250HT motor two weeks ago. After this I've done about 200km on it without any issues, it was running perfectly smooth, so I don't think that it is related.
Anyway, yesterday - I'm not 100% sure, but I think while braking (recup). The thing suddenly started to stutter. When I pedaled again, it stuttered even more. The support by the motor went on and off. I have switched to PAS level 1 which was a lot smoother, but I guess it is due to less power involved.
The speedo showed incorrect values, and when I set PAS to 0, the speedo showed 0kph.
So my assumption is at least one of the hall sensors died, but I wonder what you guys think?
Does anyone know what kind of hall sensors I need to buy? I'd like to order them ASAP, before I have the time to disassemble the motor again.
Cheers from Switzerland
Nico