First major hurdle,
I'm running a DIY setup,
I've bought an 1000w standard front hub,
I wanted to keep my hydraulic brakes but at the minute struggling for clearance,
The wheel turns but won't spin freely,
Could I sand any part of this down,
I don't think caliper adapters are going to cut it has further up the hub there are bolts .
Any suggestions
https://imgur.com/a/xdqXSWU
160mm disc also
And Shimano qhd-4 brakes
I'm running a DIY setup,
I've bought an 1000w standard front hub,
I wanted to keep my hydraulic brakes but at the minute struggling for clearance,
The wheel turns but won't spin freely,
Could I sand any part of this down,
I don't think caliper adapters are going to cut it has further up the hub there are bolts .
Any suggestions
https://imgur.com/a/xdqXSWU
160mm disc also
And Shimano qhd-4 brakes