crossbreak
1 MW
building output sprockets with a hole-saw
already told you a bit how it works. here are some pics that may show this more clearly. If you use the hole saw:
-Always step on the sheet
-Lubricate well
-Wait for your drill to cool down. It has a hard time sawing steel, let it take a no-load-break, just spin it without engaging to make it suck in cool air.
already told you a bit how it works. here are some pics that may show this more clearly. If you use the hole saw:
-Always step on the sheet
-Lubricate well
-Wait for your drill to cool down. It has a hard time sawing steel, let it take a no-load-break, just spin it without engaging to make it suck in cool air.