In dire need of help

[amberwolf]

Im getting 4.9v from the blue AND yellow at the little board on the motor.

If it's not hooked up to the controller when you test them, you could get any value, cuz the output is floating. Needs to be connected to teh controller to test them, or to an "ebike tester", or you'd have to put a resistor (10kohm will work) from the hall output to the red motor hall wire (during testing only).

 

[cruzin]

Im getting 4.9v from the blue AND yellow at the little board on the motor.

If it's not hooked up to the controller when you test them, you could get any value, cuz the output is floating. Needs to be connected to teh controller to test them, or to an "ebike tester", or you'd have to put a resistor (10kohm will work) from the hall output to the red motor hall wire (during testing only).

That is with the controller hooked up. Its the same coming straight from the controller.

I test the pin the middle on each one and they show 0.00

I opened the controller, didnt see any capacitors swelling or any burnt spots.