Hi all,
Im in the process of my first eboard build. I hooked up everything yesterday, setup the VESC for nunchuck configuration. Works like a charm sometimes. I will be ridding and the NYKO will lose communication, this is pretty dangerous as if Im cruising and hit a red light I cant break. I have to reset the controller, i.e. keep the "S" button pressed until it resets and then reconnect.
Anyone had this issue? The receiver is inside a clear acrylic enclosure with the VESC. I removed it from its original receiver casing and soldered directly to a 7pin male JST connector. The length between the receiver and the VESC is under one inch.
Thanks for your input.
I did a quick search and just found posts saying to solder the receiver which it is.
Im in the process of my first eboard build. I hooked up everything yesterday, setup the VESC for nunchuck configuration. Works like a charm sometimes. I will be ridding and the NYKO will lose communication, this is pretty dangerous as if Im cruising and hit a red light I cant break. I have to reset the controller, i.e. keep the "S" button pressed until it resets and then reconnect.
Anyone had this issue? The receiver is inside a clear acrylic enclosure with the VESC. I removed it from its original receiver casing and soldered directly to a 7pin male JST connector. The length between the receiver and the VESC is under one inch.
Thanks for your input.
I did a quick search and just found posts saying to solder the receiver which it is.