Skaiwerd, it's pretty close to dead on width (my BB is 73mm)... but probably a 2-3mm tight.. not enough to fully coprrect things.. but still a little bit in the right direction. What I was thinking... I asked above about the washers/spacers Luna provides with the kit (and actually luna's kit apparently comes bent for 100mm BB, so you have to adjust the bend anyway... BUT, they either had 1 or possibly even 2 extra spacers on the inside of the mount... which would effectively widen the width of the BB that the two mounts would need to fit around. That would also help get the bent side closer to inline. I still think there's a tiny ways to go more, but with those 2 tweaks... would def be moving in the right direction, and much closer to true.
Sadly, not having the best of luck finding a decent price on washers/spacers that are the right size... I believe it's 35mm ID... as far as metal washers/spacers that size, I've been seeing single 1mm wide ones for like $7. I'm sure there's somewhere with them cheap, just haven't found it yet, and def don't wanna wait more than 3-4 days to get them. Too bad Luna doesn't sell them, in their install video, they have a whole bin of them.
While my mount is pretty close to identical, I think the bend it came with was slgihtly different (def much closer to 68mm than 100mm) and unlike Luna's, my drive side mount does NOT have a tapered whole, instead the kit came with 1 countersunk bolt, 1 buttonhead (instead of a second countersunk).... and of course, no spacers. Everything else appears to be identical... what somewhat surprised me was what came with the mount directly from cyclone, I was expecting the 2 main pieces, a couple of bolts, maybe a couple of spacers and washers... it came with all that, BUT it also came with a different size (longer) piece of the bottom bracket shell, with a bearing, and the entire chain tensioner arm, plus a metal cable tie (this was semi confusing, since I thought one of the major benifits of the new bracket is that you no longer need this danky looking thing) and a couple of pretty serious zip ties. All in all, pretty sweet... the shipping cost somewhat negates the good deal, but I still can't get over the speed it got here, and how good their communication was.
BTW, forgot to post the video I've been referring to: https://youtu.be/G99tNdeZa0g
I think I finally found some washers/spacers similar to what Luna was using... I hope. I had measured the outside of the BB to be about 35mm, which is what I had been searching for.... then realized it might be considered 1 3/8"... so was searching for 1 3/8" washers.... which was getting me closer, but still overpriced, AND generally WAYY too big OD. After a bit, finally tried 1-3/8 in spacer... and finally landed here: http://a.co/8WcmRz3 .... putting in 1 3/8" for the ID, and a ton of items showed up, starting with an OD of 1 7/8"... which I'm thinking is exactly what I want, and instead of 1 being $6-7, can get 10 for $14-15 it looks like. Not an amazing price, but it'll work, especially with the one-day/same-day shipping. Now I just need to figure out what thickness I wanna go with... normally I'd order a couple of different in this situation, but can't say I wanna spend more than $20 on these, so gonna have to make a good choice.... and I suppose I can always double them up if needed. Tho I def need to remeasure, and really hope this is the correct size.