Hi, all. I hope the answer to this is obvious to someone, but it's defeated me so far:
Simple set up: Hub motor, KT controller, LCD3, throttle, no PAS - all was fine when I switched off last night.
Now: Throttle not working, except when 'walk mode' is on by holding the 'down' button - then I can use it to accelerate. If throttle used alone, LCD3 shows the spinning symbol, but no life from the motor. It's not set to 'use throttle only after pedal assist'.
Any Ideas?
Thanks in advance.
Simple set up: Hub motor, KT controller, LCD3, throttle, no PAS - all was fine when I switched off last night.
Now: Throttle not working, except when 'walk mode' is on by holding the 'down' button - then I can use it to accelerate. If throttle used alone, LCD3 shows the spinning symbol, but no life from the motor. It's not set to 'use throttle only after pedal assist'.
Any Ideas?
Thanks in advance.