Here's the pics of the parallel thing-a-ma-jig doodalacky connector
i made today to replace the one
Gary made for me, I was a lil bored
it was ~20c outside too cold for me to venture out seeing i needed
shorter wires and was intrigued how
Gary made the original dodalacky
parallel thing-a-ma-jig i thought i would have a go, this is how i did it AND
it works (
I know Methy doesn't read this worklog its not in the frock motor or battery section
but for the record...there were no KFF involved...again )
Simple jig to hold the bullet connectors, drilled the pcb board and MDF to ensure all lined up...
Piled on the solder (
enough?) Either way it is a interim solution, I'll organise
a replacement Infineon and Turnigy when possible and play with halls/66v
All i am waiting for now though is a single scooter wheel for the
stabilisers and the bikes ready to go i have everything else installed,
will i beat Mr
Recumpence SiR in first ride vids though
Back soon..
KiM
p.s so uhm Hyena... got pics of you charging at 50v while checking the balance of the cells at same time?
bet you aint got 6 dead Turnigys either right ... <--yeah got it in before you could..