How to connect this brushless controller to mode 48/72 volt to a key lock display

[road warrior]

How do I connect this brushless controller square wave 12 pipe 48 /72,000 w to a key lock speed display twist Auto I have it all hooked up except for the little red wire and I don't know what to connect to the blue wire that is in the connector with the yellow wire that's on throttle connectors

 

[road warrior]

How do I connect this to get my throttle to work I have everything hooked up all the plugins except for the one plug-in that has the yellow wire and it has a blue wire too and it's not connected to anything and where to connect the little red switch wire so I don't burn up the motor

 

[fechter]

The red switch wire should go to the battery through a switch in most cases. That's how you turn it on/off.
I would leave the yellow/blue alone until you can get the rest working.

 

[road warrior]

The red switch wire should go to the battery through a switch in most cases. That's how you turn it on/off.
I would leave the yellow/blue alone until you can get the rest working.

I have a key lock display twist throttle hooked up to it and when I turn the key on it shows the volts and wheel starts spinning but the throttle dose not work

 

[docw009]

Wires marked alarm and key on these controllers usually go to battery voltage, but wheel should not spin immediately without power unless the controller as a learning mode.

Is this a new controller you just bought? Does the selling link show a description and wiring diagram?

 

[E-HP]

Hard to tell exactly from the photo, but it looks like you ground and signal wires are reversed.

 

[road warrior]

Picked it up like it said and I'll take I took it out of the house and laid out the floor so I'll take pictures out better turn the key on the wheel spins will you give it throttle and nothing even with the three speed switch hooked up it don't do nothing

 

[E-HP]

How many conductors are there coming out of your motor? I don’t see the hall connector?

 

[road warrior]

Picked it up like it said and I'll take I took it out of the house and laid out the floor so I'll take pictures out better turn the key on the wheel spins will you give it throttle and nothing even with the three speed switch hooked up it don't do nothingView attachment 374772

I added a longer wire on the hotwire or the negative

Picked it up like it said and I'll take I took it out of the house and laid out the floor so I'll take pictures out better turn the key on the wheel spins will you give it throttle and nothing even with the three speed switch hooked up it don't do nothingView attachment 374772

I have the hall wires wired write together

 

[road warrior]

Wires marked alarm and key on these controllers usually go to battery voltage, but wheel should not spin immediately without power unless the controller as a learning mode.

Is this a new controller you just bought? Does the selling link show a description and wiring diagram?

Yes vits a new controller I just bought and throttle and it does have to 2 white learning wire's they are connected