Very interested in a cable for the CANbus version of the opensource bafang configuration tool.
I just replaced my old m200 with a m210 which finally has metal moving parts. I'm on my third motor, previous two m200's had nylon parts and they broke

. thank god for warranty.
However this m210 is sticking my gear, like I stop peddaling but the motor keeps pushing for about 1sec then let's go and my gear shifts. Also stops dead on 25km/s which my old m200 did not do at all it was a whole different expierence. Felt more like it helped towards 25km/s and my excess pedaling power went above that. Most of the time was going 27/28.
Now I struggle to keep up with my wifes cargo bike which I converted with a BBS02 and inferior battery to mine.
Long story short I need a cable for it to try and manipulate the settings a bit to get a working curve which is more responsive and maybe a bit more lenient towards the speed limit.
Since I saw the remark on the gitpage: "In the future program will support cheap Canable hardware, that costs from 10$ to 20$." Is there a chip I could buy from ali and make a cable out of with the right head connector? Not sure if it's male or female but I'll figure that out later.