BCTECH
1 kW
- Joined
- Oct 24, 2014
- Messages
- 320
OV_ said:GmagNeato said:Hey gang hope all is well.
It's been quite a while since I was on. I've put almost 3000 miles on my bike with no real issues to speak of.. until now.
I got caught in a pretty bad rain shower yesterday on the way to work. Had no choice but to press on and try to make it there. After a couple of miles, the motor brought me to a shuddering stop. The screen displays "Protect" when I attempt to apply throttle, and nothing happens. From that point on, the wheel drags constantly as if slight regen is applied , (heavy cogging). It does this even when I turn the controller off. Only if I disconnect one of the phase wires does the cogging stop and the motor turn freely.
Today I opened everything up except the motor, to make sure all was dry and check connections etc. I can't detect any issues in the wiring. The halls appear to be working and moving in sequence on the display H1-H6. I tried a System Reset and then an autodetect. After a few moments, I'm getting Halls e2 error message and it stops. Also, if I attempt to charge the bike through the coil, it doesn't detect a voltage and won't charge. Anyone run across similar symptoms/issues and/or have an idea what could be wrong? What else could I test to try and determine if it's a controller or motor issue? I only have a few months left on the warranty, so if it's the controller I'll need to get it sent out asap.
Greatly appreciate any help you could offer!
I have same problem: https://endless-sphere.com/forums/viewtopic.php?f=2&t=61183&start=4325#p1285676
I've contacted Adaptto via their web form two times first time 3 weeks ago and havn't got any answers :/
If u look at their sales thread: https://endless-sphere.com/forums/viewtopic.php?f=31&t=58190&start=1450 it looks pretty dead allso at their forntpage u can see Interbike 2015 ad. So the site has been updated 2015 last time?
Great urge to go for ride so I orderd this: https://endless-sphere.com/forums/viewtopic.php?f=31&t=85156 It doesn't have adapttos monitor, but there's wireless programming and they are working to have wireless dashboard "Upgrade of the hardware to enable dashboard functionality is possible and is not that hard. With some basic soldering skills, anyone can do it. I am also considering using the CA connector thar is already present on many controllers to make it fully plug and play. I may offer hardware upgrades to already sold controllers. "
Still if there's way to get Max-e working would be very nice cause it's awsome controller. But don't have all summer to wait for it...
Allso Qulbix is/was OEM distrubtor: http://adaptto.com/Services-for-OEM/ but they don't have Adaptto controllers anymore? https://qulbix.com/qulbix-products/diy/controllers
pretty much something went wrong with the phase wires, either a short on the motor or pcb on the controller. better fix and TEST the motor 100% before connecting to the adaptto again.
if you are very very lucky, fix the short on motor might be ok. otherwise a trip to Russia.