Bafang G510/M620 (Bafang Ultra) thread

[amberwolf]

May not be helpful, but this is Pushkar from WW, AFAIK

Quirkyneo

endless-sphere.com

 

[Paul Fithian]

Anyone have experience with an M620 mid drive mated to a 3x3Nine hub for a heavy bakfiet or cargo bike?

 

[smorgasbord]

There is not enough discussion on program settings, would you mind sharing yours?

I started this thread over on EBR a few years ago:

Ultra Tuning: Master Thread -- Start Here!

If you're starting out to tune, or re-tune, your Bafang Ultra G620/M510 motor, you've come to the right place. There's a lot to setting up an Ultra to ride the way you want, but if you take it a step at a time it won't be as daunting. You don't have to do them all at once - I actually recommend...

forums.electricbikereview.com

 

[Paul Fithian]

I am setting up a bakfiet with an M620 mid-drive. I would like to add a shift sensor, but not sure where to plug it in. I found these 2 empty connectors after removing the cover, can you folks advise what these are for?

 

[DPC18RI]

A 4 pin black one is usually for battery communication. If you already have a connected speedsensor and it's working then the one marked as nr 1 could be a candidate for a shift sensor i would think for your bakfiets.

 

[Paul Fithian]

Thanks, greatly appreciated! Is a referance service manual PDF available for the M620?

 

[TPEHAK]

Anyone wants to build VESC controller for Bafang m620?

Archon X1 Programming Thread (questions and experiences)

I played around a little bit and was finally able to connect via VESC Tool to my Innotrace X1! First I made connection using a simple USB to CAN adapter (e.g. canable) and tried to send common VESC CAN commands (VESC CAN-Bus Communication). I got no response and assumed it has been either...

forums.electricbikereview.com

 

[TPEHAK]

I am setting up a bakfiet with an M620 mid-drive. I would like to add a shift sensor, but not sure where to plug it in. I found these 2 empty connectors after removing the cover, can you folks advise what these are for?

You can download the reverse engineered Innotrace X1 schematics, there are all m620 connections with illustrations


I believe the shift sensor is this one