This LM335 was pre-wired and heatshrunk with only two pins, so the V(adj) pin is probably not used. it doesn't need a +5 supply like the LM35, it is a zener style, and relies on the pull up inside the CA.. Anyway. Motor side covers are back on, and I'll give it a test run to see how it performs, if it's noisy or causes feedback issues I'll open the motor back up and probably re-wire the whole thing. new phases etc.
but I imagine you can't mix and match halls
I actually think you "may" be able to. The halls are physically mounted on the same "phase / coil" but on the other side of the motor, and wired colour for colour, so I think they could be interchangeable. I've not thought long and hard about this but gut feeling is it would work. I could always test....
I am very much waiting for a full powered thrash.. but am holding off wiring the battery in until I get the anti-spark connectors and the 100A breaker. The reason is the battery and controller wires are very short and the more I add / remove connectors the shorter they get. and I don't want too many soldered extensions in the system.
On the plus side i got my chargers today
![20131217_174224 (Custom).jpg 20131217_174224 (Custom).jpg](https://endless-sphere.com/sphere/data/attachments/68/68950-a5e4de24abcf328ee2396b61450c0c4b.jpg)
I'll have to change the connectors on the bigg'un Also, powering up and testing only gave 74.5V on the small charger, the big on had 0V.. but I figure it's a "output on detect" type circuit, so until a battery is plugged in, can't tell.
Andy