cnrd said:buba said:Could you reset everything and see if that helps?
------------------------
Step 1: Go to the Configuration Menu
Step 2: Go to the "Reset to factory defaults" under General Setup
Step 3: Increment the number until the screen is blank/turns off
Step 4: When the screen is blank/off, hold the ONOFF button for a couple of seconds. This is important!
Step 5: Release the ONOFF button
Step 6: Power on...
Hey thanks
Unfortunately nothing seems to help, I did also try flashing the alpha2, nothing.
The motor works fine with marcoq 0.3.5 and the stock display, so the motor does work.
I think that I may have messed up the wiring, I cut the male connector off a bafang 1-to-4 cable and soldered on a female connector, using the following mapping:
Bafang - TSDZ2
Brown - Blue
Orange - Red
Green - Brown
White - Green
Yellow - Yellow
Red - White
Blue - Orange
Black - Black
Used this picture for bafang pinout: https://electricbike.com/forum/filedata/fetch?id=77817&d=1541800588
I also put a female connector on the KT-LCD3 with the following mapping:
Wire color - Solder pad
Yellow - Red
Blue - Blue
Red - Black
Black - Green
Green - Yellow
I had to do this as the stock bafang display pinout does not match the KT-LCD3.
Are these correct? Or is there a guide somewhere that I missed on how to create the cable?
Sorry, it was a long time ago I connected everything and I am not the best to help with these kind of things but:
https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/Wire-LCD-to-TSDZ2
Maybe someone else here on the thread can help?