I need some help. I can't get my motor to give any assistance. I flashed the KTLCD3 to v.0.12, and my TSDZ2 to v0.12. The LCD3 gave a validation error, but I reflashed and it verified ok.
I wired up the LCD3 as per wiki and can configure it, and see the read speed settings from the wheel etc. I can read all the settings in section 9. I have configured it for 10 cells (36v) is section 1, set the max amps, wheelsize. i even reset it to defaults and tried again. I have no way of trying back the original 36v firmware as I stupidly did not make a copy so have no way of knowing if this is a hardware issue or not. in section 9 get a reading from parameter 2 ADC torque sensor, but only a 0 reading from the parameter 3 - Pedal torque sensor. Walk mode does not work. The wee man shows on the LCD but nothing happens. I'm thinking I have a hardware fault on the TSDZ2.
Can any help ? can anyone supply me with the original version of the firmware to flash with STlink ? so I can try the original TSDZ2 VLCD 5.
Thanks
I wired up the LCD3 as per wiki and can configure it, and see the read speed settings from the wheel etc. I can read all the settings in section 9. I have configured it for 10 cells (36v) is section 1, set the max amps, wheelsize. i even reset it to defaults and tried again. I have no way of trying back the original 36v firmware as I stupidly did not make a copy so have no way of knowing if this is a hardware issue or not. in section 9 get a reading from parameter 2 ADC torque sensor, but only a 0 reading from the parameter 3 - Pedal torque sensor. Walk mode does not work. The wee man shows on the LCD but nothing happens. I'm thinking I have a hardware fault on the TSDZ2.
Can any help ? can anyone supply me with the original version of the firmware to flash with STlink ? so I can try the original TSDZ2 VLCD 5.
Thanks