jeff.page.rides
100 W
- Joined
- Aug 13, 2019
- Messages
- 295
r0mko said:casainho said:You should wait for a new firmware version or try an older one, and, use a fuse in series with the battery wire to try avoid the same to happen (I would say a car fuse of 5 amps).
No problem, I can build whatever firmware and flash it right away. I need my bike back as soon as possible, so I have to decide:
switch to 36V setup with the old motor, controller and battery
or
put a 36V controller with a 48V motor and run in from the 48V battery
Just a suggestion but, Buba uses a 36 Volt motor with a 52 Volt battery set at 36 Volt for the motor. That was his favorite. If you have the hardware give it a try the only downside I've read is that it may or may not be possible that the 36 Volt motor would put out more heat. I've been wanting to try this combination because he claims you get more torque above 50 RPM this way. I don't have an extra 36 Volt motor and don't have the funds to buy one so I haven't been able to test it yet.